Opening your pool: step by step

Before the first swim, check the fence and its gate, then get the water right by testing sanitizer, pH, total alkalinity and calcium hardness. All season long, test daily (Health Canada). No official source gives an opening date.

Work out my pool's volume

The steps

  1. Check the fenceThe gate must close and latch on its own, and nothing should help a child climb over: in Quebec, the filter and other equipment sit more than 1 m from the pool wall or fence. The pool safety guide has the details.
  2. Check your chemicalsA sanitizer (chlorine, bromine, salt chlorinator) must be registered: its label carries a Pest Control Products Act registration number (Health Canada). Take unlabelled products to a household hazardous waste site.
  3. Test the waterMeasure sanitizer, pH, total alkalinity and calcium hardness with a good test kit, or bring a sample to your pool dealer (Health Canada).
  4. Adjust, one product at a timeAim for the levels in the table below. Follow the label's dose for your volume of water, and never mix two products.
  5. Shock, if neededHealthLinkBC describes raising chlorine to 10 times the normal concentration. Wait until free chlorine is back in range before anyone swims.
  6. Test every dayDuring the season, test the water daily, especially when the pool gets a lot of use. Even clear water can carry germs (Health Canada).
Levels for residential pools, from HealthLinkBC (British Columbia).
MeasureIdealMinimum and maximum
Free chlorine2 to 4 ppm0.5 to 5 ppm
pH7.2 to 7.67.2 to 7.8
Total alkalinity80 to 120 ppm80 to 120 ppm

Handling pool chemicals safely

  • Wear gloves, goggles and shoes. Use a separate clean plastic or metal scoop for each product.
  • Add the chemical to the pool water unless the label says otherwise. Never mix chemicals, and never put a spill back in its container.
  • Keep products in their original containers, somewhere cool, dry, ventilated and out of the sun, away from children, pets, food, gasoline, fertilizers and other flammables. Store liquids below powders.
  • If there is a fire, use lots of water, never a dry-chemical extinguisher. If you cannot put it out right away, leave and call the fire department.
  • In case of poisoning, call a poison control centre right away.

During the season

  • Never leave a child alone in or near the pool, even one who can swim (Government of Quebec).
  • Do not dive into an above-ground pool: it is not deep enough.
  • After swimming, take floating toys out of the water so a child does not fall in reaching for one.
  • No alcohol before or while swimming.

More guides

🌾 When to seed grass in Canada🧪 When to fertilize your lawn🛟 Quebec pool safety rules✂️ When to trim a hedge🍂 When to mulch🌳 When to plant a tree or shrub🧤 Getting the garden ready for winter🪴 Growing vegetables on a balconyWork out my pool's volume

Sources for this guide

Advice is restated from these sources, not copied, and every figure comes from one of them.

Sources — pool: HealthLinkBC (British Columbia); units from the Weights and Measures Act; guides: government and university sources cited in each guide.

Updated .

Frequently asked questions

When should I open my pool?

No official source gives a date. What matters is that the fence and gate are in order before the water can be reached, and that you can test the water daily once the pool is in use.

Do I need to shock my pool when I open it?

Not always: the water test tells you. A shock treatment, as HealthLinkBC describes it, raises chlorine to 10 times the normal concentration; you then wait for free chlorine to come back into range before swimming.

How much chlorine should I add to my pool?

The amount the label gives for your volume of water: strengths vary from one product to another. Work out your pool's volume with Potagel's tool first; it then scales the label's dose to your litres.

Can I mix two pool chemicals?

No. Health Canada says never to mix chemicals together: add them one at a time, straight into the water.